Topics

1

General Mach Discussion / laser software

« on: December 11, 2012, 04:54:01 AM »

what I can use with mach3
I need engraving image and text  cut out plate same work And of course easy use and visual

2

General Mach Discussion / laser setings

« on: November 15, 2012, 02:28:17 AM »

hi I want ask  how I can make settings for laser ?

Yes I can make lazy cam code for dxf mode  plasma and run and cut ok

But I want make z axle convert fire for laser beam like that then z go negative beam its start burn and if it go deep give more voltage and more power and z go 0.00 or positive beam end

Or how I get digital trigger work ?

my board tb6550 blue 4 axle

and I use relay for beam control   output 1 pin 2  work ok in lazy cam in plasma mode

do I get z axes data in pin and make transitor circuit swiths run beam ?
but I make vector cut artcam pcb  code and I run in mach work very good milling virtual  works ok

but not work start code and beam not response z control  beam start if I code run and end then code end but not lift up z axle control