Guest
Show Posts
1
LazyTurn / Roughing and Finishing not matching up!
« on: November 06, 2015, 06:17:57 AM »
Hi,
I am fairly new to lazyturn and have been processing some test drawings, so that we can use the program for an easy solution in my school.
I managed to get on well with a good looking results in the virtual display, so that the finished items do not show any obvious problems.
When I send the code to Mach3, the finish path looks like it's operating in radius mode, in that the x axis movements are reduced by half!
I may be doing something silly, but can't figure it out.
The attached example uses just one tool to keep it simple.
Anyone got any suggestions?
Many thanks
John
I am fairly new to lazyturn and have been processing some test drawings, so that we can use the program for an easy solution in my school.
I managed to get on well with a good looking results in the virtual display, so that the finished items do not show any obvious problems.
When I send the code to Mach3, the finish path looks like it's operating in radius mode, in that the x axis movements are reduced by half!
I may be doing something silly, but can't figure it out.
The attached example uses just one tool to keep it simple.
Anyone got any suggestions?
Many thanks
John