Topics

1

General Mach Discussion / Mach3 to control X axis punch press?

« on: October 18, 2016, 09:47:55 PM »

I am a lighting manufacturer that is trying to build a mach3 controlled  x axis manual kick punch press.  I need to measure the length of the door frame with some type of sensors and then determine what length it is, then get the spacing of the holes required and move the product in the x axis to the 1st location and stop while I punch the hole. (like a tool change)  Once punched I need to tell it to go to the next location  (like a tool change) and then punch the next hole. and on....
http://fineartlight.com/cncpunch/cncpunch.jpg

My door frames have holes 7- 9" O.C depending on it's length and have lots of various size.  for example my 12" has two holes,  18" with three holes, 22" with three holes...  etc.....

Each part has a tolerance of +- 1/8"  of it's size and floats in the opening of the light.  When attached to the x axis I do not have an accurate way of attaching this each part needs to be measured and then moved to the correct starting position.

Any ideas on how to do this?

David Munson
FineArtLight LLC
Manchester, MO
David.Munson@FineArtLight.com

2

VB and the development of wizards / help on 3 Buttons to remember positions a,b,c, and 3 buttons to return to same.

« on: November 12, 2012, 10:24:17 AM »

I need some help on creating 3 Buttons to remember positions a,b,c, after jogging around.  and 3 buttons to return to same positions so i can change tooling.

I have been reading for about 18 hours straight and am stumped.

thanks in advance