Hello Guest it is November 30, 2023, 11:35:04 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - rafterj

Pages: 1
I don't know what this means.  When the message appears the light next to the Z-axis readout turns from green to red and the z-axis on the table goes all the way up.  I can reference all axis, switch to the coordinates button and sometimes I will not get the message and all is good and then the next time its not.  I have an EZ-Router APC plasma table.  Any and all assistance is greatly appreciated.

Pages: 1