Topics

1

General Mach Discussion / How to - fixture save...without exiting

« on: January 17, 2014, 05:48:09 AM »

I feel this may be redundant question, but after some search, can’t find answer to my question !

Is there any way I can have the fixture changed saved just like when exiting Mach where the FIXTURE CHANGED dialog box asking “fixture save?” question…..without exiting / closing Mach?!?
Tks

2

General Mach Discussion / Safe_Z setup…literature please !?

« on: September 21, 2013, 01:03:23 PM »

Hi all….
Is there any literature on the Safe_Z setup config ??
I’m getting some “puzzled” and confusing ( confusing in relations to my experience tweaking Mach3 !! ).
I would be grateful to read a throughout detail literature on the in & out of these….simple options !?
Tks, Robert 

3

General Mach Discussion / Stand alone/dual set up or grouped in one ?

« on: April 17, 2007, 07:44:12 AM »

Hi all,
I’m a new guy in this group and this is my first post.
Excuse me for not searching to long in the data base for this coming question <:0))

Can some one confirm me if it is better to run Window,Mach3 and a Cad/Cam software on a stand alone separate computer and have a second one with all the software & connections you have/like to work with ??
I was told for a given type of configuration / tower set up, the “dual” set up permits Mach3 to run better / smother / faster ?
Has any one done / knows if this is /can be true or fiction ??

Thanks
Robert M