Topics

1

LazyCam (Beta) / No tabs

« on: May 18, 2008, 05:53:33 PM »

Hi Brian

Finely I have A reasonable Lcam file bud I cant create tabs in it.
I try to create tabs 2mm long 0,4mm high and 2,3 or 4 tabs per item.
I think it has somethink to do with multiple pass cuts because i made A similar file that cuts in one pass and there works tabbing fine.
I send here the Lcam and the tap file.

Greetings:
Willem

2

LazyCam (Beta) / move entitie to another chain in Lazycam

« on: May 13, 2008, 11:14:57 AM »

Hi Brian

Could you make it possible to move entities from one chain to another chain.
As you can see in the picture if I select an chain on the outside then entities in the inside are selected as well.
I want to cut the entities in the inside of the shape 0,5mm deep and the shape as it is must be cut 1,5mm deep.
So I need all the entities inside the shape to be one chain and the outside of the shape to be another chain so I can cut in different ways.

Greetings:
Willem

3

LazyCam (Beta) / Front side turning

« on: June 01, 2007, 05:33:45 AM »

Hi Art and Brian

Is there a chance you can spend a little bit attention on front side turning.
I find it diffecult to make a shape on the front side of the material.

Greetings:
Willem

4

LazyCam (Beta) / Zoom box

« on: May 23, 2007, 03:02:56 AM »

Hi Brian

Just a litle report.
If i select ZOOM BOX on the right side of the screen and i hit with the left mouse button one's , a point on the screen (without moving the mouse) my image is disappeared.

Greetings:
W.Jansen

5

LazyCam (Beta) / no toolpath

« on: May 20, 2007, 05:43:06 PM »

Hi all

Is there someone who can tell me what is wrong with this dfx.
I cant seem to get a toolpath in the complete shape.
It is for turning.

Greetings:
Willem

6

General Mach Discussion / nasty mach3 problem

« on: May 19, 2007, 12:47:48 PM »

Hi Art

Here i have a very nasty problem.
I made a file (aouterprofile6.tap) in Lazycam.
When i load this file in Mach3 and regen than i get a toolpath as in turn fout.jpg (watch the green zigzag line in the center of the screen)
When i zoom in and then move around Mach3 shuts down with no warning or whatsoever.
Also when i run the file (no machine attatched) Mach3 suddenly shuts down on no special point.
If i load first an other file and after that this file everything looks okay.
If i load this file on an other computer i get a toolpath as in fout2.jpg and everything works okay.
So i can not reproduce this error on another computer although it happend ones before on a other computer.
I can easely get arround this error but i think you like to know.

Greetings:
Willem