Hello Guest it is July 19, 2019, 11:41:22 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Poul Munch

Pages: 1
1
General Mach Discussion / Strange extra cuts with R3.043.066
« on: October 16, 2012, 04:33:29 PM »
Mach 3 with release r.3.43.066 and r3.43.056 produce some extra circles thar are not in the project. Release r3.042.020 do not do these extra unwanted circles. File with code attached.

Best regards
Poul Munch Andersen

Pages: 1