1
General Mach Discussion / Please Help!! Mach 3 homing issues
« on: October 05, 2012, 01:10:44 PM »
Hi,
I am new to this forum so any help would be greatly appreciated. On the program run screen I am getting an abnormal condition message when I reference all axis home. When I click on the abnormal condition tab it reads "Axis are not Refed to normal condition". If I turn the controller on and jog around everything is fine normal condition appears until it homes out. I ran a program with no problems until I increased the feed rate then the machine ran away. Luckily I e stopped it before it crashed. I am thinking that this has something to do with the abnormal condition message. What could I try to fix this problem?
I am new to this forum so any help would be greatly appreciated. On the program run screen I am getting an abnormal condition message when I reference all axis home. When I click on the abnormal condition tab it reads "Axis are not Refed to normal condition". If I turn the controller on and jog around everything is fine normal condition appears until it homes out. I ran a program with no problems until I increased the feed rate then the machine ran away. Luckily I e stopped it before it crashed. I am thinking that this has something to do with the abnormal condition message. What could I try to fix this problem?