1
General Mach Discussion / Mach3 Turn spindle index problem
« on: April 17, 2013, 08:51:48 PM »
I just completed a lathe conversion and the spindle index is giving me fits.
Ive got a CNC4PC C-3 spindle index card send the output to a Campbell Design BOB
The C-3 output is blinking when I turn the spindle but Mach doesn't appear to see it.
Ive attached the xml
Any advise would greatly appreciated
Thanks
Todd
Ive got a CNC4PC C-3 spindle index card send the output to a Campbell Design BOB
The C-3 output is blinking when I turn the spindle but Mach doesn't appear to see it.
Ive attached the xml
Any advise would greatly appreciated
Thanks
Todd