Hello Guest it is December 03, 2021, 03:04:20 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - 415porto

Pages: 1
1
SmoothStepper USB / ESS / G540 / PMDX-126 WTF? About to give up
« on: April 28, 2014, 08:43:52 PM »
 Hello All
I am trying to integrate a Smooth Stepper / G540 / PMDX-126.  I understand the G540 is its own breakout board but I just want to use it as a motor driver.  I spoke with PMDX and they said it was possible to get this to work by (I think) hooking up the G540 to PMDX-126 (J19).  Smooth Stepper Port1 to PMDX Port 1 and Smooth Stepper Port 2 to  PMDX Port 2.  I am not sure what I am doing wrong but I just cannot get it to work.  I am pretty sure I am missing some things in ports and pins and maybe some other things in Parallel Port / Smooth Stepper settings.  Any advice / detailed instructions / Application Notes would be greatly appreciated. I have wasted well over 40 hours trying to figure this out when I am pretty sure there is a simple solution.  I am about to give up and call it a day, which I really don’t want to do.  Please advise

Pages: 1