1
General Mach Discussion / Irregular height of material possible?
« on: September 25, 2012, 01:29:22 PM »
Hi! I'm new in this cnc area, so I need some advice from the guys who do know...
I want to mill some 3D stuff which is very irregular in height and volume.
In some areas it's a lot of material, in some areas it's minor. Total area is approx. 4' x 8' (48"x96") (120x240cm).
Is it possible to stack material in different height (see attached picture) depending on where it's needed, and tell the program/machine/Mach3 to work just where the material is placed?
Thx
//Mike
I want to mill some 3D stuff which is very irregular in height and volume.
In some areas it's a lot of material, in some areas it's minor. Total area is approx. 4' x 8' (48"x96") (120x240cm).
Is it possible to stack material in different height (see attached picture) depending on where it's needed, and tell the program/machine/Mach3 to work just where the material is placed?
Thx
//Mike