1
G-Code, CAD, and CAM discussions / New setup
« on: September 23, 2012, 07:52:07 PM »
I have a new router from ebay. I have a licensed copy of Mach3. I am just setting it up. I have not been able to cut anything. The motors are buzzing and trying to move but don't. Then I found a demo gcode on here of a scorpion. The router runs perfectly with that code in there. If I try to even cut the roadrunner file in the mach3 software, nothing but buzzing. Any idea what I might have done wrong?
Thanks, Darrel
Thanks, Darrel