1
General Mach Discussion / I need a simple step by step instrutions on setting up an ATC in Mach3
« on: May 16, 2017, 06:50:50 PM »
I am a dummy when it comes to programming. I use a conversational g code programmer. But after that I'm am lost.
I have a Colombo ISO 15 auto tool change spindle and have set up all the air controls and valves to operate it.
I have build a side rack tool holder that needs to have the tool holder move in from the side and then unlock and go up.
But I have tried looking at all the macros and other stuff and can not even start to under stand. Weirdly , I can program I/O electrical plc's. But not this.
I am willing to pay if needed.
Thanks, Sam
I have a Colombo ISO 15 auto tool change spindle and have set up all the air controls and valves to operate it.
I have build a side rack tool holder that needs to have the tool holder move in from the side and then unlock and go up.
But I have tried looking at all the macros and other stuff and can not even start to under stand. Weirdly , I can program I/O electrical plc's. But not this.
I am willing to pay if needed.
Thanks, Sam