Hello Guest it is August 20, 2019, 05:33:49 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - Chuck

Pages: 1
General Mach Discussion / Ports & Pins gets reset automatically
« on: April 14, 2007, 10:14:05 PM »

the X-Alis "Step Pin#" in the "Motor Outputs" tab gets set to some random pin number everytime.

I have to manually set it back to 2 everytime and after some time, it gets set back to some other random pin number.

Any idea what causes this and how can I prevent it from happening again?

Thanks in advance.

Pages: 1