Hello Guest it is November 25, 2020, 05:45:49 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - phillip t

Pages: 1
1
General Mach Discussion / G540 XML File for Mach3 Turn. Please Help !!
« on: December 20, 2012, 10:08:51 AM »
Hello Everybody,

I need help with getting my Gecko G540 working with Mach 3 Turn. I am not very good at editing XLM Code. If anybody has any suggestions, I would love to hear from you.
Sincerely,
phillip~

2
I have been using Mach3 for years. I am a newbe to the forums. Now I am getting into threading with Mach3. I am trying to get my C3 Pulse Indexer to work in Mach3 with a Gecko G540.
My question is this,
Shouldn't I see a light flashing on the diagnostics page when I rotate my spindle?
Thank's
phillip

Pages: 1