Hello Guest it is October 20, 2021, 10:09:46 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Garf

Pages: 1
1
Hello,

I'm using a plasma CNC since 2-3 years and would like to add it a THC. Connection seems fine but have a problems with mach3 that I can not understand.

First I'm using the "test mode" of my THC. (command up and down for 1sec each to move the spindle)

During the test I can see on the THC the commands UP/DOWN.
I receive the signal in MACH3 but my spindle does not move.



Anyone has already face this problem? and solved it :)

There is also some of my configurations:
Plasma              :  hypertherm powermax 85
THC                  :  compact THC controller from PROMA elektronika
Motor command : Box CNC-shop with board TB6560
A SmoothStepper to convert USB to parallel port


Pages: 1