1
General Mach Discussion / RefAllHome vs motor tuning vs Homing/Limits
« on: August 18, 2013, 11:03:29 PM »
HI ! I'm new here as with mach3 and found a relation between homing/Limits, Motor Tuning and RefAllHome.
when I press ' REFALLHOME '; I get no motor moving on individual axis if velocity value set to 30 or lower,but works fine over-it ...
- Same thing happen for homing/limit _ speed% less then 15 ... is-it normal ?
Someone can confirm this or explain me ?
when I press ' REFALLHOME '; I get no motor moving on individual axis if velocity value set to 30 or lower,but works fine over-it ...
- Same thing happen for homing/limit _ speed% less then 15 ... is-it normal ?
Someone can confirm this or explain me ?