1
General Mach Discussion / ArtCAM
« on: February 07, 2013, 01:49:52 AM »
Hi
Has an one being using Delcam’s Artcam Express it look good but I don't know how it will work with Mack3. Artcam sets the Z high at the stock surface where Mack3 sets Z at the top Home position, how do you work around this.
Does ArtCAM have a post Processor for Mach3.
Eric
Has an one being using Delcam’s Artcam Express it look good but I don't know how it will work with Mack3. Artcam sets the Z high at the stock surface where Mack3 sets Z at the top Home position, how do you work around this.
Does ArtCAM have a post Processor for Mach3.
Eric