1
SmoothStepper USB / Ethernet SmoothStepper Configuration
« on: August 29, 2012, 05:08:04 PM »
Hello Community,
Using a Syil X6 Mill with Mach3.
Switched from a parallel port connector to an Ethernet SmoothStepper.
The most up to date plug-in is installed from the Warp9TD website.
I am able to connect to Mach3 and all the LEDs are blinking. My question lies in the PlugIncontrol Menu.
Attached are the two setup windows. One is the Configuration Dialog and the other is the Data Monitoring Status.
Please does anyone have any information on the recommended settings for these two setup windows or any documentation that may assist me???
Thank you,
Kevin
Using a Syil X6 Mill with Mach3.
Switched from a parallel port connector to an Ethernet SmoothStepper.
The most up to date plug-in is installed from the Warp9TD website.
I am able to connect to Mach3 and all the LEDs are blinking. My question lies in the PlugIncontrol Menu.
Attached are the two setup windows. One is the Configuration Dialog and the other is the Data Monitoring Status.
Please does anyone have any information on the recommended settings for these two setup windows or any documentation that may assist me???
Thank you,
Kevin