Guest
Show Posts
1
LazyTurn / Complex figures
« on: September 17, 2012, 12:41:51 AM »
Hello, I'm learning right now how to use my "lathe" and my question is if it's possible with this software to get non-symmetrical figures such as a hand or the horse figure for a chess.
I went through the dxf's and I see the figure that Mach Turn uses is a profile to work with. I'm curious since my lathe is a 4 Axis machine so the Z axis can move up and down easier than the cutting piece of a lathe.
Thanks
I went through the dxf's and I see the figure that Mach Turn uses is a profile to work with. I'm curious since my lathe is a 4 Axis machine so the Z axis can move up and down easier than the cutting piece of a lathe.
Thanks