Guest
Show Posts
1
General Mach Discussion / control of older servo control hardware by mach3
« on: August 13, 2012, 01:48:04 PM »
Is there any reason why mach 3 could not drive older controls formerly driven by dos software?
It seems to me if you know the pin assignments of the old controller you should be able to
drive it with Mach. Or is this wishfull thinking?
I have an old Servo Impact 2 machine, nice little machine but old controls from the late 1990's
It seems to me if you know the pin assignments of the old controller you should be able to
drive it with Mach. Or is this wishfull thinking?
I have an old Servo Impact 2 machine, nice little machine but old controls from the late 1990's