Hello Guest it is April 12, 2021, 07:18:19 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - giosig

Pages: 1
General Mach Discussion / setting multipul milling depths
« on: March 03, 2006, 08:06:21 PM »
I'm new to Mach 3 is there an easy way to set different cutting depths in the same part file with out haveing to edit g codes? i had a shop-bot and in their software all i had to do was assign the depth to what ever colors i had drawn in the part file.  simply. if i have two circles in a file how do i mill one deeper than the other one
thanks giosig

Pages: 1