1
General Mach Discussion / Replaced my motherboard. Now I am having problems getting back up and running.
« on: December 02, 2013, 05:01:57 PM »
I purchased a machine a while back and it has been working great until it developed a limit switch triggered problem. That came and went for a while and the motherboard went. I replaced the motherboard and now I am not sure where to start.
My machine is a knee mill that the previous owner setup to be controlled with Mach 3.
I replaced the motherboard and the video card and was thinking I would be back up and running using my existing settings. Now when I fire my machine up, my drives are all engaged but my home and limit switches are all lit up for all three axis.
Can someone please tell me where to start? I am in the middle of a production run and need to gett back up and running. I would love to be able to talk to someone about the setup I have so I understand it better.
Please help???
Thanks,
Matt
612-490-5696
My machine is a knee mill that the previous owner setup to be controlled with Mach 3.
I replaced the motherboard and the video card and was thinking I would be back up and running using my existing settings. Now when I fire my machine up, my drives are all engaged but my home and limit switches are all lit up for all three axis.
Can someone please tell me where to start? I am in the middle of a production run and need to gett back up and running. I would love to be able to talk to someone about the setup I have so I understand it better.
Please help???
Thanks,
Matt
612-490-5696