1
General Mach Discussion / Mach 2 Screen Questions
« on: April 11, 2007, 12:55:37 PM »
I'm trying to slowly understand this program. So far it works alright, but what exactly does the following "circled" items do?
Output1 is red; is this normal? It seems that anytime I have problems, this is red... then again, it may always be on, (not sure?)
And when I set the spindle to 100 is bumps up to 10000 after running through the drilling process... why would the spindle change in speed?
Any ideas would be great.
Output1 is red; is this normal? It seems that anytime I have problems, this is red... then again, it may always be on, (not sure?)
And when I set the spindle to 100 is bumps up to 10000 after running through the drilling process... why would the spindle change in speed?
Any ideas would be great.