Hello Guest it is September 21, 2019, 10:55:57 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - TNTRacing

Pages: 1
1
Sieg Machines / Z Axis only travels in 1 direction
« on: July 22, 2012, 02:24:13 AM »
I just purchased a KX1, to get started in hobby CNC, after setting it up to test the motors I found movement on all axis except the +Z. Ive switched out the drivers on the machine and checked all wiring. Ive traced it back to either the parrallel port or the software/comp issue.

Has anyone else experienced this issue??? What was the final resolution?

Im not familiar with Mach3 so Im hoping it is an inproper setting or configuration issue.

Any help would be greatly appreciated.

Pages: 1