Hello Guest it is April 14, 2021, 04:17:42 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Jccnc

Pages: 1
1
General Mach Discussion / Inputs not working
« on: July 14, 2012, 12:59:34 PM »
I have mach 3 setup but my inputs are not working in mach 3. The inputs are working even in the computer. I can see the input pin states change using paramon. The outputs for the same parallel port are working to drive the motors from mach3. On the diagnostics page in mach3 the pin states do not indicate a change. If i try to do automatic setup of inputs the state changes are not recognized. Does anyone know what can cause this problem and how to fix it?

Pages: 1