Hello Guest it is March 28, 2024, 01:00:26 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - PMS

Pages: 1
1
Galil / Anilam Crusader M conversion To DMC-1830 pic card
« on: July 14, 2012, 02:10:10 AM »
I am converting a mill from an Anilam Crusader M control to a Galileo DMC-1830 PCI card.  The original dc servo motors and drives are wired in and I do get digital read out.  The Mach3 is talking to the Galileo card but when I turn on the motors the X axis holds position and the Y axis runs away.  If I switch the motors with the drives the X motor runs away and the Y motor holds position.  I have tested the servo drives and they are ok.  How do I stop the motor from running away long enough to set up and calibrate the Mach3?
Thanks,
Paul

Pages: 1