1
General Mach Discussion / Engraver Conversion
« on: July 16, 2012, 08:28:18 PM »
Hi folks,
I'm new to Mach 3 so this may be a dumb question...
I am converting an ancient Dahlgren 300 engraver from the DOS world into this millennium. This all seems workable except that I'm a little stuck on Z axis control. There is no stepper here- just a relay to move the cutter up and down. (control is actually electric valve pneumatic)
The question- how do I configure Mach 3 for this kind of "binary" control?
Also, I plan to use this setup with either Engravelab or Flexi Engrave. Any comments on these 2 pieces of software would be appreciated!
Thanks!
I'm new to Mach 3 so this may be a dumb question...
I am converting an ancient Dahlgren 300 engraver from the DOS world into this millennium. This all seems workable except that I'm a little stuck on Z axis control. There is no stepper here- just a relay to move the cutter up and down. (control is actually electric valve pneumatic)
The question- how do I configure Mach 3 for this kind of "binary" control?
Also, I plan to use this setup with either Engravelab or Flexi Engrave. Any comments on these 2 pieces of software would be appreciated!
Thanks!