1
General Mach Discussion / Mach3 machine startup problems
« on: July 02, 2012, 03:51:47 PM »
I am new to mach3 and am trying to set up a small gantry cnc machine.
As soon as I start and press reset the machine runs to a stop switch and will do nothing until moved back off the stop. I can't run a test or set limits etc.
Any suggestions.
Richard
As soon as I start and press reset the machine runs to a stop switch and will do nothing until moved back off the stop. I can't run a test or set limits etc.
Any suggestions.
Richard