Hello Guest it is January 20, 2021, 09:08:45 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Anthony

Pages: 1
1
General Mach Discussion / 4th axis Teach
« on: May 08, 2008, 04:47:19 AM »
Hi,
  Can Mach3 Software be used to teach the 4th axis (wizard "Teach") ? Thank you.

            Anthony

2
General Mach Discussion / External buttons
« on: April 27, 2008, 03:34:43 AM »
Hi,
 Who can explain me how to find a pin for connecting an external button "cycle start" and an external button "go to Z" ?
Thank you.

regards


Anthony

3
German / ├ťbersetzung
« on: April 01, 2008, 02:40:29 PM »
Hallo,
Wer kann mir in Englisch ├╝bersetzen dieses Blatt bitte?

gruss

Anthony

4
General Mach Discussion / Milling machine
« on: March 28, 2008, 02:29:00 PM »
Hi,
Who can tell me how to use a milling machine in a program GCode (to turn it on and switch off) ?
Thank you.


 
  Regards,                                                    Anthony


5
General Mach Discussion / Timings
« on: February 25, 2008, 03:28:20 AM »
Hi,
 Can you tell me how to put timings in a GCode program ?

 Thank you

6
General Mach Discussion / How to use sensors in Mach3 ?
« on: February 19, 2008, 01:32:04 PM »
Hi,
 Can you say me how to use sensors in Mach3 ? I want to use sensors in a GCode.

    Thanks

7
General Mach Discussion / How to configure my machine ?
« on: June 28, 2007, 12:57:39 PM »
I have a problem of adjustment about the steppers motors of my robot 4 Axis (Y, X, Z, A), on each axis there is a sensor, I don't manage to move the robot, my controller is SM44PCV5. Who could find a solution for me?
Thank you very much for your help.

Anthony

8
General Mach Discussion / Configuration Mach3 for my machine
« on: April 08, 2007, 04:19:06 PM »
Hi,
I am French, I have a problem with my machine CNC 4-Axis because I don't manage to configure it. I have a controller SM44PCV5 which comes from company GWR Elektronik. I have the handbook of the controller but it is in german and I don't understand german. Can you help me to configure my machine with Mach3 please ? Thank you.
Please contact me, kotobeco@free.fr.

Pages: 1