1
General Mach Discussion / Increasing feedrate when threading
« on: November 03, 2013, 11:05:45 AM »
Hi!
I am having a problem when I am cutting threads on my lathe.
I have been using the lathe threading wizard and it has worked perfectly.
I build myself a new cnc-case with new Gecko drivers and all the electronics etc. and now I am running into a big problem.
I am cutting an 1 mm thread and the first pass goes smoothly at 1 mm / revolution. The machine goes to the start again but the second, third... pass is at 2.11 mm / revolution?
Could it be an index problem? I have steady readings from the sensor to Mach.
Regards
Per
I am having a problem when I am cutting threads on my lathe.
I have been using the lathe threading wizard and it has worked perfectly.
I build myself a new cnc-case with new Gecko drivers and all the electronics etc. and now I am running into a big problem.
I am cutting an 1 mm thread and the first pass goes smoothly at 1 mm / revolution. The machine goes to the start again but the second, third... pass is at 2.11 mm / revolution?
Could it be an index problem? I have steady readings from the sensor to Mach.
Regards
Per