Topics

1

General Mach Discussion / G540, Huangyang VFD and soindle control

« on: April 25, 2014, 08:07:58 PM »

Hy guys did a search on this and am now more confused...,      So i will put the question to you whom r much smarter than me!!

What is the EASIEST and most bullet proof way to control a 2.2KW chinese spindle with a Huangyang VFD ??

Or if i have missed the threas for this... could you please p[oint me in the right direction.

Thank you kindly in advance 

2

General Mach Discussion / Best Pendant/MPG

« on: June 04, 2013, 07:13:20 PM »

Hi Guys, I was wondering what your favourite Pendant/MPG is. I am currently looking at the Tormach one on their website. But am open to suggestions.  Also can someone confirm for me please that the Tormach pendant  will run under Mach3 with no issues please.

Thanks in advance. 

3

General Mach Discussion / Tool Offsets

« on: March 25, 2013, 04:13:49 AM »

Hi guys, I am trying to get "Tool Offsets" to work under the G55 command.
I have created a tool in the tool list and saved it. However when i go to the "Offsets" page and turn it on, only the tool length changes on the DRO. NOT the diameter!... Any ideas would be most appreciated.

Thanks.

4

General Mach Discussion / Upgrade of licenced version

« on: January 06, 2013, 07:18:48 PM »

Hi guys,

Apparently I need to do an upgrade to a later version so I can use the latest set of  M10/M11 codes for switching a laser.

 I have a fully licensed version on disk,  R3.043.022 .  Where is the UPGRADE for licenced versions located . ( I can only find the DEMO download.Sorry for such a dumb question. 

Thanks in advance.

5

General Mach Discussion / Mach3 controlling Co2 Laser

« on: January 06, 2013, 03:26:04 AM »

Hi Guys.

 I currently have my x y table finished running under Mach3. It all works nicely. Now it's time to take the next step and install a 100 watt Co2 Laser. I have done some research but being a newbie I cant understand how to control the laser with Mach3. Could someone please explain it all in NEWBIE terms so I can understand it. I only wish to use Vector files for cutting lite ply. No rastering is necc. So all i need I think is an on off switch, although some way to adjust laser power would be a great advantage.

Thanks in advance.

Warped.