1
General Mach Discussion / material orientation on table
« on: June 19, 2012, 10:56:49 PM »
Hi
I'm new at this. Just got a g 6 table with a mach3 controller.
There's a dialog box for orienting the plate on the table.
I cannot remember the steps to get to it.
Can someone please help?
Thanks for your help
I'm new at this. Just got a g 6 table with a mach3 controller.
There's a dialog box for orienting the plate on the table.
I cannot remember the steps to get to it.
Can someone please help?
Thanks for your help