1
General Mach Discussion / Error during first cycle start
« on: July 14, 2013, 07:26:42 PM »
Hello, I have Mach 3 Version R3.043.066 installed, since a few days i have the next problem,
WHEN i start mach 3 in my PC the first time, I load the file and when press the cycle start button the machine goes to any where. Dont respect the file
When this happens I stop, I go to zero, and press again cycle start and work ok
Does someone had the same problem?
Thanks lot
WHEN i start mach 3 in my PC the first time, I load the file and when press the cycle start button the machine goes to any where. Dont respect the file
When this happens I stop, I go to zero, and press again cycle start and work ok
Does someone had the same problem?
Thanks lot