1
Mach3 and G-Rex / Mach3 Joggin Y & Z normally, X is slow like molasses
« on: June 03, 2012, 04:42:01 PM »
I learned earlier how to jog using CTRL + J and have been alternating between functions today. The only problem is that my X axis now seems to be stuck on the slower jog rate. All my Motor Tuning is the same for the axises, and everything has worked well. Z & Y alternate fine between the speed rates.
Restarted Mach3, Rebooted computer, and checked all the jogging settings. My diagnostic screen is not showing any limits setup.
I can still set to the lower jog rate (and then everything moves the same speed). Why is just my X axis stuck on tortoise? Please help!
Appreciation in Advance...
Restarted Mach3, Rebooted computer, and checked all the jogging settings. My diagnostic screen is not showing any limits setup.
I can still set to the lower jog rate (and then everything moves the same speed). Why is just my X axis stuck on tortoise? Please help!
Appreciation in Advance...