Hello Guest it is March 29, 2024, 02:29:11 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - lxapilot

Pages: 1
1
General Mach Discussion / Z-Axis zero help!
« on: June 02, 2012, 05:15:56 PM »
Occasionally my Mach-3 will randomly reset the zero height of my z-axis in the middle of running a G-code--causing the bit to ruin my piece on the way to its next location.  This appears to happen when running a g-code longer than about 15,000 lines or so.  If I run the same code over again, the same thing happens, but in a different place...I don't see anything wrong in the code.  Has anyone else had this issue?  Thanks in advance.

Pages: 1