Topics

1

G-Code, CAD, and CAM discussions / subroutine creation help!!

« on: June 10, 2012, 04:10:06 PM »

Hi everybody.

I'm doing well with all help I ready here on this forum. I need a little help with my doubt.

I need to make an output activate on start of circle cut and put a timer on that output to deactivate before circle end.
I try to use the function sleep but the circle wont start till sleep finish, maybe I putting in wrong sequence, any help will be very welcome.

thanks, wonderful day for all!

2

General Mach Discussion / Gcode help need?

« on: June 03, 2012, 06:40:33 PM »

 
Hi everybody,
I'm very new to Mach3, but I do not give up easily. I need help to start on Gcode, any help will be very welcome.

Please anyone read the description below and give some help to start this G code. I hope I can keep learning and doing all modification needed in future.
Sequence:
Apply glue over a circle line

Start

1- go to tool position
2- activate valve 1 to lock tool( stay locked till need change tool)
3- go to waiting position (stay till input signal come on line 4)
4- input signal to enable job start
5- go to circle start position
6- lower Z to position
7- start circle job
8- activate valve 2 to dispense glue
9- deactivate valve 2 at the circle end
10- go to waiting position on line 3

thanks all

Darli