1
General Mach Discussion / Cutter Radius Compensation Error
« on: April 14, 2016, 05:47:01 AM »
Dear all,
I am using Mach3 Software in a Hot Wire Cutting Machine and the Mach3 is installed in a PC with Windows 7, 32 bit.
When the GCode loads, for most GCode programs I am getting the following message: "Tool Radius greater than approach Line xx”.
I have attached the GCode for the MDP 41/4 which is loads without any error and the GCode for the MDP 20/4 loads with the above mentioned error.
Thank you very much for your time.
Best regards,
George
I am using Mach3 Software in a Hot Wire Cutting Machine and the Mach3 is installed in a PC with Windows 7, 32 bit.
When the GCode loads, for most GCode programs I am getting the following message: "Tool Radius greater than approach Line xx”.
I have attached the GCode for the MDP 41/4 which is loads without any error and the GCode for the MDP 20/4 loads with the above mentioned error.
Thank you very much for your time.
Best regards,
George