Hello Guest it is March 29, 2024, 08:55:34 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - oicis

Pages: 1
1
General Mach Discussion / THC up/down dont moving Z axis
« on: May 24, 2012, 10:55:32 AM »
Hi.

We have plasma & mach3 with http://www.cs-lab.eu/en/index.php?m=gallery&s=show&fid=48&sort=&uinfo=CSMIOIPS_6_axis_CNC_Ethernet_Motion_Controller_STEPDIR motion controller & http://proma-elektronika.pl/cnc-plasma-thc-controller-torch-height-control/ THC controller . On diagnostic screen Torch up / Torch down LED lit, but Z axis dont moving, on "ports & pins/Mill options" "Allow THC UP/DOWN Control even if not in THC mode"  checked.

Thanks.

Ojars

Pages: 1