Hello Guest it is March 28, 2024, 01:52:08 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Yesd0g

Pages: 1
1
General Mach Discussion / Noob Configuration Help
« on: May 23, 2012, 01:04:19 AM »
Hi folks, having some trouble and need some advise.

Just got my small 20x26 router up and running, and I'm having trouble with Mach3.

Everything worked fine with LMC2, so I'm pretty sure wiring is correct.

Issues -
1. When Jogging X and Y, axis moves in same direction when pressing +/-
2. Z axis doesn't move at all
3. Motors are screaming at me

About the drivers and build -

XYdrive XD14 bob
XYdrive XD8 drivers

Step Time - Min. 1u
Step Space - Min. 1u
Direction Hold - Min. 200us
Direction Setup - Min. 200us

Motors -
Vexta Nema 23 PK266-02A
2 Phase 1.8 /step

PSU 24v switching 12.6 amp

Acme thread 1/10 single start

Any assistance is appreciated!

Pages: 1