Topics

1

General Mach Discussion / need help with mach3 geckodrive deepgroove1

« on: May 19, 2012, 09:57:35 PM »

hope someone can help me, I have a taig 2019 with geckodrive g540 controll I purchased from deep groove1 a couple months ago and I finally got time to set it up. I installed mach 3 , loaded the g540 xml and my license. I fought through most of the problems but now im stuck. under ports and pins all the drives have numbers 2-9 listed. the x axis will move but only one direction(will move with either jog key just in same direction), the z axis key makes the y axis jump around and the y axis jog keys do nothing. I have been running and programming haas funuc etc. machines for 15 years so I know about cnc's but this thing has got me so frustrated im about to sell it, any help or suggestions will be greatly appreciated.