1
General Mach Discussion / Z axis moves up 2 inches after I start G code start cycle
« on: May 18, 2012, 12:23:23 PM »
When I Z zero my CNC using auto zero with plate and start cycle Z axis jumps 2 inches higher than normal and air cuts. When I Z zero manually by jogging to surface of material machine works as normal. I'm using mach 3 control software.
can Anyone help me with this issue? I checked offset screen to make sure my gage block info is correct.
can Anyone help me with this issue? I checked offset screen to make sure my gage block info is correct.