Hello Guest it is November 18, 2019, 09:59:02 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - hd28vsb

Pages: 1
1
I am slowly starting to retrofit my Hurco 3 axis Sm1 cnc mill. I am going to use the 90 VDC  servo motors that are on the mill.
I occasionally get to check the forums and have been reading posts on Galil cards and Grex .
I want to have a stable accurate machine when I am finished.  What route would I best take ?
Is the bugs worked out with the Galil Mach combo and the  Grex ??
Should I go with Rutex drives since the servos are 90 Volt?
I have been a machinist for quite a few years but this electronic business is like "magic" to me so I appreciate all responses.

Thanks

Pages: 1