Hello Guest it is March 29, 2024, 07:12:00 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - salvanosalvador

Pages: 1
1
General Mach Discussion / Mach weak output help
« on: April 28, 2012, 10:40:14 AM »
I am trying to drive one stepper and I connected the circuit and tested it using the Breakout board software, the motor spins perfectly but with Mach3 the axis pul LED in the BB just have a dim light and the motor don't spin >>>>I think it is the output signal from mach so How can I change it?

Help PLEASE

Pages: 1