1
General Mach Discussion / Axis movement limited to 1"? Demo Version??
« on: April 09, 2007, 09:41:17 AM »
Hello,
I have downloaded the demo version and I am getting my mill all setup.
If I go the the MDI screen and inout G0 X.75 everything is fine, But if I go over an inch my motors start doing weird things and dont travel much more than an inch. Is this a limitation of the demo version?
Also if I jog the axis with the hot keys everything is fine.
Thanks
I have downloaded the demo version and I am getting my mill all setup.
If I go the the MDI screen and inout G0 X.75 everything is fine, But if I go over an inch my motors start doing weird things and dont travel much more than an inch. Is this a limitation of the demo version?
Also if I jog the axis with the hot keys everything is fine.
Thanks