Hello Guest it is March 25, 2023, 02:14:48 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - gtxkid

Pages: 1
  I have a mill setup with Mach and been having a hard time getting it going.
I think we are close but i would like to call someone to go threw a quick trouble shooting. 


General Mach Discussion / How do you change motor direction.
« on: December 19, 2012, 10:20:36 PM »
  I have x axis moving in the +X with both arrow keys.
I have Y doing the same thing.
I have Z that is dead.
Could use any help that you have.

   I seen it all work when i bought it.
I am new.
I can not seam to get reset to stop flashing.
The emergency stop works, that is how i got it to stop stepping z down about .020 every two seconds.
What would it take for someone to call me for 5-10 min. to check a few things.
Thanks Greg

Pages: 1