Hello Guest it is March 29, 2024, 04:23:11 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - getrolfed

Pages: 1
1
I have just finished assembling a new controller for a Routermaster 52. It all seems to work fine, but I need to rotate my image by 180 degrees. I am assuming this is possible.

When I load Gcode it displays correctly in the toolpath window. When I run it, it cuts out by 180 degrees. I suppose the simple solution would be to turn my maching around, but thats not really a solution.

Any ideas?

(please have a look at the attached images)

Thank you

Pages: 1