Guest
Show Posts
1
General Mach Discussion / Lost code.
« on: April 04, 2012, 12:40:20 PM »
Hello everyone.
I am learning to use MeshCAM for generating G code. It seems very user friendly. I have question though. MeshCam shows the tool path before saving the G code file. On one part I'm working on the tool path shows just what I'm looking for. I save the file and then load it on Mach3. When it pulls up only part of it shows up on Mach3. That's really odd. I tried to save the G code as a few different file types that Mach3 also can pull up but every time the same thing results.
Does anyone have any idea what could cause this?
Thanks again.
I am learning to use MeshCAM for generating G code. It seems very user friendly. I have question though. MeshCam shows the tool path before saving the G code file. On one part I'm working on the tool path shows just what I'm looking for. I save the file and then load it on Mach3. When it pulls up only part of it shows up on Mach3. That's really odd. I tried to save the G code as a few different file types that Mach3 also can pull up but every time the same thing results.
Does anyone have any idea what could cause this?
Thanks again.