1
General Mach Discussion / Reverse Run and 'Radius to end of arc differs from radius to start' problems
« on: April 02, 2007, 08:24:51 PM »
I'm trying to resolve two issues with Mach3. I'm using it for plasma with THC300 using SheetCam but seem to have the same problem using Gcode samples.
'Radius to end of arc differs from radius to start' error occurs on Version but not versions can anyone help with this?
I haven't been able to get the 'Reverse Run' button to work. It either does nothing or gives error message: Cannot find recovery points. Solution too complex, or Nothing to freehold.
rayhager7
'Radius to end of arc differs from radius to start' error occurs on Version but not versions can anyone help with this?
I haven't been able to get the 'Reverse Run' button to work. It either does nothing or gives error message: Cannot find recovery points. Solution too complex, or Nothing to freehold.
rayhager7