1
General Mach Discussion / Anyone running CandCNC's PlazPak1A along with the MPG101B Pendant
« on: November 17, 2007, 04:26:21 AM »
I am a complete newby to CNC.
Looking for some help to get going with my table. I have everything set up, have installed mach3, Run in Candcnc support CD. I have had everything on & can get movement on the DRO(s)
I need a bit of help calculating steps for my motors & tuning them.
I have not been able at this point to get any movement from the stepper motors. I don't know what I am missing. My home & limit switches all seem to be wired & functioning properly. I have no LED lit on the table I/O card indicating a problem there.
I must admit, even after reading the manuals repeatedly, I don't know what question(s) to ask.
Looking for some help to get going with my table. I have everything set up, have installed mach3, Run in Candcnc support CD. I have had everything on & can get movement on the DRO(s)
I need a bit of help calculating steps for my motors & tuning them.
I have not been able at this point to get any movement from the stepper motors. I don't know what I am missing. My home & limit switches all seem to be wired & functioning properly. I have no LED lit on the table I/O card indicating a problem there.
I must admit, even after reading the manuals repeatedly, I don't know what question(s) to ask.